User Manual

MATRICE 200

Series User Manual

Preight Checklist

1. Remote controller, Intelligent Flight Battery, and mobile device are fully charged.

2. Propellers are mounted correctly and rmly.

3. Micro SD card has been inserted, if necessary.

4. Gimbal is functioning normally.

5. Motors can start and are functioning normally.

6. The DJI GO 4 app is successfully connected to the aircraft.

7. Ensure that the sensors for the Obstacle Sensing System are clean.

Calibrating the Compass

Only calibrate the compass when the DJI GO 4 app or the status indicator prompts you to do so.

Observe the following rules when calibrating your compass:

DO NOT calibrate your compass where there is a chance of strong magnetic interference,

such as near magnets, parking structures, or steel reinforcements underground.

DO NOT carry ferromagnetic materials with you during calibration such as cellular phones.

The DJI GO 4 app will notify you if the compass is affected by strong interference after

calibration is complete. Follow the prompts to resolve the compass issue.

Calibration Procedures

Choose an open area to carry out the following procedures.

1. Tap the Aircraft Status Bar in the app and select Calibrate, then follow the on-screen instructions.

2. Hold the aircraft horizontally and rotate it 360 degrees. The Aircraft Status Indicators will go solid

green.