User Manual

MATRICE 200

Series User Manual

2. MounttheZenmuseXTontotheaircraftbysecuringthegimbaladapter.

Mounting the Upward Gimbal and GPS Module

The built-in compass and GPS will fail to work if a single upward gimbal is in use. And the D-RTK

antennas cannot receive the GPS signal when the aircraft is flying under a bridge or other tall

buildings. It is recommended to mount the extended GPS module when a single upward gimbal is

in use in situations like this.

External GPS Module Single Upward Gimbal Connector

Follow the steps below to mount the Upward Gimbal and GPS Module.

Remove the D-RTK antenna

on the left side (facing the

aircraft nose) and mount the

GPS module.

Connect the GPS module

to the Extension Port, and

ensure that the side with

the logo faces upward

Mount the

upward gimbal,

and connect it to

the DGC2.0 port.

Make sure you secure the GPS module and upward gimbal’s cables with the cable clamps for

safety.

The GPS module must be installed on the left side when facing the aircraft nose. Note that the

whole aircraft will not retain its IP43 rating if the GPS module is installed.

Single upward gimbal connector and dual downward gimbal connector should be used

separately. DO NOT use them at the same time.