User Manual

Mavic 2 Pro/Zoom User Manual
Exiting ActiveTrack 2.0
Press the Flight Pause button on the remote controller to brake immediately. Tap on the screen
or toggle the Flight Mode switch to S-mode on the remote controller to exit ActiveTrack 2.0. After
exiting ActiveTrack 2.0, the aircraft hovers in place, at which point you may choose to fly manually,
track another subject, or return to home.
Point of Interest 2.0 (POI 2.0)
Select a static subject as the Point of Interest. Set the circle radius, flight altitude, and flight speed.
The aircraft flies around the subject according to these settings. Mavic 2 Pro/Zoom supports
selecting the POI through GPS positioning and selecting on the screen.
In flight (GPS)
Position
12
61%
09:29
ISO
SHUT TEREV
WB
CAPACITY
1600
1/8000
0.3
4K/25
4K/24
Point of Interest
P
Radius
Height
Speed
GO
--m
50m
8m/s
1. Select POI on the screen: drag a box around the desired subject and tap the “GO” icon on the
screen. The aircraft starts to measure the location of the subject and flies around the subject once
it measures the location successfully. Use the gimbal dial to adjust the subject framing. The circle
radius, flight altitude, and flight speed can also be adjusted during flight.
It is recommended to select a static subject (e.g., high-rise buildings, mountainous terrain) at a safe
distance from the aircraft (further than 10 m). Do not select a subject that is too near the aircraft.
Avoid selecting a subject without a clear pattern (e.g., a clear blue sky).
Avoid selecting subjects that are too small.
Select a subject with a clear outline. Otherwise, the subject may not be centered correctly onscreen.
The aircraft cannot be controlled while the location is being measured, but the measuring can be
stopped using the control sticks, Flight Pause button, Flight Mode switch, and the “STOP” icon.
2. Select a subject through GPS positioning: Manually fly the aircraft above the subject, and then
press the C1 button or select in DJI GO 4 to confirm the subject. Fly the aircraft at least 5 m away
from the Point of Interest. The flight speed and the circle direction can be set in DJI GO 4. Tap
“GO” to start flying. Use the gimbal dial to adjust the subject framing. The circle radius, flight
altitude, and flight speed can also be adjusted during flight.
The GPS positioning has no altitude measurement.
It is recommended to adjust the gimbal tilt to -90° to make it easier to measure the GPS
location.
© 2018 DJI All Rights Reserved. 29