User Manual

Mavic 2 Pro/Zoom User Manual

Flight Mode Switch

Toggle the switch to select the desired flight mode.

Position Flight Mode

S S-mode

P P-mode

TT-mode

T P S

Regardless of which position the switch is in on the remote controller, the Mavic 2 Pro/Zoom begins

in P-mode by default. To switch flight modes, first go to Camera View in DJI GO 4, tap and enable

“Multiple Flight Modes”. After enabling multiple flight modes, toggle the switch to P and then to S or T

to switch flight modes.

RTH Button

Press and hold the RTH button to start the Return to Home (RTH) procedure where the aircraft

returns to the last recorded Home Point. Press this button again to cancel RTH and regain control of

the aircraft. Refer to the Return to Home section for more information about RTH.

C1 and C2 Button

The functions of the C1 and C2 buttons are set in DJI GO 4. The default configuration for the C1

button is Center Focus and the default configuration for the C2 button is Playback.

Remote Controller Alert

The remote controller sounds an alert during RTH or when the battery level is low (6% to 15%). The

RTH and low battery alert level can be cancelled by pressing the power button. The critical battery

level alert (less than 6%), however, can not be cancelled.

Optimal Transmission Zone

The signal between the aircraft and the remote controller is most reliable when the antennas are

positioned in relation to the aircraft as depicted below.