User Manual

Mavic 2 Pro/Zoom User Manual

Starting/Stopping the Motors

Starting the Motors

A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the inner or

outer bottom corners to start the motors. Once the motors have started spinning, release both sticks

simultaneously.

Stopping the Motors

There are two methods to stop the motors:

Method 1: When the aircraft has landed, push and hold the left stick down. The motors stop after

three seconds.

Method 2: When the aircraft has landed, conduct the same CSC that was used to start the motors,

as described above. The motors stop immediately. Release both sticks once the motors

have stopped.

Method 1 Method 2

Stopping Motors Mid-Flight

Stopping the motors mid-flight will cause the aircraft to crash. The motors should only be stopped

mid-flight in an emergency situation such as if there is a collision, a motor has stalled, the aircraft is

rolling in the air, or the aircraft is out of control and is ascending/descending very quickly. To stop the

motors mid-flight, use the same CSC that was used to start the motors.

Test Flight

Takeoff/Landing Procedures

1. Place the aircraft in an open, flat area with the Aircraft Status Indicator facing towards you.

2. Turn on the aircraft and the remote controller.

3. Launch DJI GO 4 and enter Camera View.

4. Wait until the Aircraft Status Indicator blinks green indicating that the Home Point has been

recorded and it is now safe to fly.

5. Gently push the throttle stick to take off or use auto-takeoff.

6. Pull the throttle stick or use auto-landing to land the aircraft.

7. Turn off the aircraft and remote controller.