Mini 3 Pro - User Manual v1.0
©
2022 DJI All Rights Reserved.
71
DJI Mini 3 Pro
User Manual
Using DJI Assistant 2 (Consumer Drones Series)
Update the aircraft and remote controller rmware separately using DJI Assistant 2 (Consumer Drones
Series).
Follow the instructions below to update the aircraft rmware:
1. Launch DJI Assistant 2 (Consumer Drones Series) on your computer and log in with your DJI
account.
2. Power on the aircraft and connect the aircraft to the computer via the USB-C port within 20
seconds.
3. Select DJI Mini 3 Pro and click Firmware Updates.
4. Select the rmware version.
5. Wait for the rmware to download. The rmware update will start automatically.
6. Wait for the rmware update to complete.
Follow the instructions below to update the remote controller rmware:
1. Launch DJI Assistant 2 (Consumer Drones Series) on your computer and log in with your DJI
account.
2. Power on the remote controller and connect it to the computer via the USB-C port.
3. Select the corresponding remote controller and click Firmware Updates.
4. Select the rmware version.
5. Wait for the rmware to download. The rmware update will start automatically.
6. Wait for the rmware update to complete.
Make sure to follow all the steps to update the rmware, otherwise the update may fail.
The rmware update will take approximately 10 minutes. It is normal for the gimbal to go limp, aircraft
status indicators to blink, and the aircraft to reboot. Wait patiently until the update is complete.
Make sure the computer is connected to the internet during the update.
Before performing an update, make sure the Intelligent Flight Battery has at least 40% power and the
remote controller 30%.
Do not unplug the USB-C cable during an update.
Aftersales Information
Visit https://www.dji.com/support to learn more about aftersales service policies, repair services, and
support.