User Manual

Camera

To avoid possible serious injury and property damage, observe the following rule:

1. DO NOT block any ventilation holes on the camera as the heat generated may hurt you and

damage the device.

1. Check camera settings before use to make sure you can adjust them to t your needs.

2. Test the camera by shooting a few test images and check that it is operating correctly before

shooting important pictures or videos.

3. DO NOT remove the Micro SD card from the aircraft when it is powered on.

4. Photos or videos cannot be transmitted or copied from the camera if the Intelligent Flight

Battery is powered off.

5. Be sure to power off the Intelligent Flight Battery correctly, otherwise your camera parameters

will NOT be saved and any recorded videos may be damaged. NOTE: Regardless of the reason,

DJI will not be responsible for any failure of an image or video to be recorded or having been

recorded in a way that is not machine readable.

Gimbal

1. Precision elements in the gimbal may be damaged in a collision or impact, which may cause

the gimbal to function abnormally.

2. Avoid getting dust or sand on the gimbal, especially in the gimbal motors.

3. DO NOT apply external force to the gimbal after the gimbal is powered on.

4. DO NOT add any payloads to the gimbal, as this may cause the gimbal to function abnormally

or even lead to motor damage.

5. Make sure you remove the gimbal protector before powering on the aircraft. Also, make sure

you mount the gimbal protector when the aircraft is not in use.

Compass

To avoid possible serious injury and property damage, observe the following rule:

1. Calibrate the compass or change the location if the compass is affected by interference.

2. Land immediately when obvious drifting occurs in flight, i.e., the aircraft does NOT fly in

straight lines.

Only calibrate the compass when the DJI GO 4 app or the status indicator prompt you to do so.

Observe the following rules when calibrating your compass:

1. DO NOT calibrate your compass where there is magnetic interference, such as interference by

magnetite, parking structures, or steel reinforcements underground.

2. DO NOT carry ferromagnetic materials with you during calibration such as cellular phones.

3. The DJI GO 4 app will prompt you to resolve the compass issue if the compass is affected by

strong interference after calibration is complete. Follow the prompted instructions to resolve

the compass issue.