User Manual

Slide Lever controls the pitch of the H3-2D and

H3-3D gimbal. The position of slide lever

determines the pitch angle relative to the

horizontal level.

Slide the lever left to make the gimbal pitch

down up to a -90° position.

Slide the lever right to pitch up to +0° position

resulting in gimbal being at a horizontally level

orientation.

（1） For ‘Ready to Fly’ the aircraft will hover when all sticks are released.

（2） For ‘Ready to Fly (non-GPS)’ the aircraft will only keep the altitude when all sticks are released.

3.5 Linking the remote controller& built-in receiver

PHANTOM 2 has a built-in receiver, the link button and indicator located on the bottom of the aircraft as illustrated

in the Figure 3-4.

The link between the remote controller and aircraft is already established for you so you can initially skip this

procedure. If you ever replace the remote controller, re-establishing the link is required.

Link button &

Link indicator

Figure 3-4

Linking procedures

1. Power on the PHANTOM 2.

2. Turn on the remote controller and place it 0.5m~1m away from the aircraft.

3. Push the link button with a thin object and hold it until the Link indicator blinks red, then release it.

4. When the Link indicator turns solid green, the link between the remote controller and the built-in receiver

has been successfully established.

Link Indicator

Status

The remote controller is linked with the receiver successfully.

The remote controller is turned off and there is no 2.4GHz signal around, please turn

on the remote controller.

The receiver is ready for linking.

There is 2.4GHz signal around but the remote controller is not linked with the receiver,