User Manual

（1） Users should not enable the Naza-M function before finishing Advanced Flight Maneuvers

procedure in the " PHANTOM Pilot Training Guide”. If the Naza-M mode is enabled, users can

switch the control mode between ATTI. Mode, GPS Mode or Manual Mode, and access the

advanced settings (e.g. IOC). In addition, the LED located on the rear frame arms will display

Naza-M flight status indications instead of the PHANTOM 2's indicators. Do not enable the

Naza-M mode unless you are an experienced user or guided by a professional.

（2） You can change to the Phantom 2 mode by clicking the same button used to turn on the Naza-M

mode. This operation will disable the Naza-M mode and enable Phantom 2 mode. All parameters

will be returned to factory settings.

7.3 Firmware upgrade of PHANTOM 2

Please refer to the PHANTOM 2 Assistant Software to install driver and PHANTOM RC Assistant Software, and

then follow the procedures below to upgrade the software and firmware; otherwise the PHANTOM 2 might not

work properly.

1. An internet connection is required to upgrade PHANTOM 2’s firmware.

2. Click the [Upgrade] icon to check the current firmware version and whether the installed firmware is the

latest version. If not, click the relative links to upgrade.

3. Be sure to wait until the Assistant Software shows “finished”. Click OK and power cycle the PHANTOM 2

after 5 seconds. Once completed, the firmware is up to date.

Firmware upgradable items

Current firmware version

Upgrade link

*This image is for reference

only. Please refer to the

actual user interface.

（1） DO NOT power off until the upgrade is finished.

（2） If the firmware upgrade failed, the main controller will enter a waiting for firmware upgrade

status automatically. If this happens, repeat the above procedures.

Firmware upgradable items:（1）Main Controller（2）P330CB(Main Board)（3）Receiver（4）Gimbal

CMU（5）Gimbal IMU（6）Battery