User Manual

©2014 DJI. All Rights Reserved.
Home Point
When the aircraft is initializing the Ready to Fly status, the aircraft will record the current GPS coordinates as the
home point. It is recommended to lift off only after Ready to Fly status is confirmed for the safety of being able to
fly back to home point successfully in case the Failsafe mode is initiated.
Go Home Procedures
1 Record Home Point.
2 Flying.
3 Remote controller signal lost.
5 Fly back to home point.4 Signal lost lasts 3s, begin to go home.
6 Landing after hovering 15s.
LED Flight Indicator
à
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
OFF CAM ON WIFI ON
MICRO SD
LED Flight Indicator
LED Flight Indicator
LED Flight Indicator LED Flight Indicator LED Flight Indicator
Height over home point<=20m
Height over home point>20m
20m
Elevate to 20m
In a Failsafe situation, if less than 6 GPS satellites are found for more than 20 seconds, the aircraft will
descend automatically.
In Phantom 2 Vision mode, users can set a new home point manually when the aircraft is in “Ready to
fly” status as long as a home point has been recorded automatically. Quickly flipping the S2 switch of
the remote controller from upper most to lower most positions 5 times or more will reset the current
aircraft position as a new home point of PHANTOM 2 VISION. When successfully reset, you will see a
series of rapid green blinks on the LED Flight Indicator. The definition of “home point” is: i) The home
point is the place PHANTOM 2 VISION returns to when the control signal is lost, which is recorded last
time. ii) The home point is used to calculate the horizontal distance between you and the aircraft, the
distance will be displayed on the DJI VISION App.
Regaining Control During Failsafe Procedure
Position of Switch S1
Position-1
Position-2
Position-3
How to regain control
When the S1 switch is switched to Position-1,
toggle the S1 switch to any other position once to
regain control. If remote controller’s signal is
recovered, control is returned back to the pilot.
Regain control as soon as signal
is recovered.