User Manual

(1)

(2)

(3)

(4)

(5)

Firmware upgradable items:

Main Controller

GPS

5.8G Receiver

P330CB (Main Board)

Battry

13.4 PHANTOM RC Assistant Software Description

Please follow the procedures to finish the configuration of the remote controller.

Turn off the remote controller and find the Micro-USB port on the back of it. (If there is no one, users

should open the rear cover to find the Micro-USB port on the board inner the remote controller.)

Start up the PC, power on the remote controller, and then Connect the remote controller to the PC with a

Micro-USB cable. DO NOT disconnect until the configuration is finished.

Run the PHANTOM RC Assistant Software and wait for the remote controller to connect to the Assistant

Software. Observe the indicators on the bottom left of the screen. When connected successfully,

the connection indicator is and communication indicator is blinking .

Finish configuration in the [Main] page.

Finish upgrade in the [Info] page if necessary.

Language swap

Main page

Connection indicator

Communication indicator

Firmware upgrade

Account, software

version

*This image is for

reference only. Please

refer to the actual

user interface.