User manual

Remote Controller

Phantom 3 Standard

User Manual

Position 1

Position 3

LinkingProcedures

1. Turn on the aircraft and press the Link Button. The button will blink red when the aircraft is ready to link.

2. Switch on the remote controller, turn the gimbal dial to the far left, and toggle the S2 switch back and

forth quickly for at least three times. You will hear a pulsating beep sound when the remote controller is

trying to link to the aircraft.

3. The remote controller will stop beeping and the Link Button on the aircraft will turn solid green if linking

is successful.

LinkingtheRemoteController

The Phantom 3 Standard is linked to the remote controller by default, and re-linking is only necessary if

the remote controller is replaced with a new one. Refer to the gure below to locate the Link Button.

Link Button

Switch S2

Linking Status

LinkButton Description User Action

— Glows solid red No RC signal Switch on the RC or perform a linking procedure

Blinks red Ready to link Switch on the RC

— Glows solid green Linked to RC Linking successful

CE or FCC Compliance

The remote controller complies with CE compliance as default. Switch between CE and FCC is

automatically adjusted according to the GPS locations acquired by the DJI GO app.