User manual

©
2015 DJI. All Rights Reserved.
43
Flight
Phantom 3 Standard User Manual
Flight Test
TakeoffandLandingProcedures
1. Place the aircraft on an open, at ground with the battery indicator facing towards you.
2. Power on the remote controller and your mobile device, and then the Intelligent Flight Battery.
3. Launch the DJI GO app and enter Camera View.
4. Wait until the Aircraft Status Indicator ashes green. This means the Home Point has been recorded
and it is safe to y. If it ashes yellow, the Home Point has not been recorded and you must not
take off.
5. Slowly push the throttle stick up or use Auto Takeoff to take off.
6. To land, hover over a level surface and gently pull down on the throttle stick to descend slowly.
7. After landing, execute the CSC command or push the throttle stick down for 3 seconds until the motors
come to a stop. Do not release the control stick until the motors come to stop completely.
8. Turn off the Intelligent Flight Battery, followed by the remote controller.
Stopping the Motors
There are two methods to stop the motors.
Method 1:
When the aircraft has landed, push the throttle stick down, then perform the CSC command to
stop the motors. Release both sticks once the motors have stopped.
Method 2:
When the aircraft has landed, push the throttle down and hold. The motors will stop after 3
seconds.
Starting and Stopping the Motors
The Combination Stick Command (CSC) illustrated below is used to start or stop the motors. Ensure you
perform the CSC command in one continuous motion.
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
OR
Method 1
OR
Method 2
DO NOT perform the CSC command when the aircraft is ying in mid-air.