User Manual

Aircraft

INSPIRE 1

User Manual

Battery Level Indicators while Charging

LED1 LED2 LED3 LED4 Battery Level

0%~25%

25%~50%

50%~75%

75%~100%

Fully Charged

Charging Protection LED Display

The table below shows battery protection mechanisms and corresponding LED patterns.

Battery Level Indicators while Charging

LED1 LED2 LED3 LED4 Blinking Pattern Battery Protection Item

LED2 blinks twice per second Over current detected

LED2 blinks three times per second Short circuit detected

LED3 blinks twice per second Over charge detected

LED3 blinks three times per second Over-voltage charger detected

LED4 blinks twice per second

Room temperature is not suitable

for charging

LED4 blinks three times per second

Room temperature is not suitable

for charging

After any of the above mentioned protection issues are resolved, press the button to turn off the Battery

Level Indicator. Unplug the Intelligent Flight Battery from the charger and plug it back in to resume

charging. Note that you do not need to unplug and plug the charger in the event of a room temperature

error, the charger will resume charging when the temperature falls within the normal range.

DJI does not take any responsibility for damage caused by third-party chargers.

How to discharge your Intelligent Flight Battery:

Slow: Place the Intelligent Flight Battery into the Inspire 1’s Battery Compartment and power it

on. Leave it on until there is less than 8% of power left, or until the battery can no longer

be turned on. Launch the DJI Pilot app to check battery level.

Rapid: Fly the Inspire 1 outdoors until there is less than 8% of power left, or until the battery can

no longer be turned on.