User Manual

Aircraft

Mavic Pro

User Manual

Charger

Intelligent Flight Battery

Power Outlet

Battery Level Indicators While Charging

LED1 LED2 LED3 LED4 Battery Level

0%~25%

25%~50%

50%~75%

75%~100%

Fully Charged

Battery Protection LED Display

The table below shows battery protection mechanisms and corresponding LED patterns.

Battery Level Indicators while Charging

LED1 LED2 LED3 LED4 Blinking Pattern Battery Protection Item

LED2 blinks twice per second Over current detected

LED2 blinks three times per second Short circuit detected

LED3 blinks twice per second Over charge detected

LED3 blinks three times per second Over-voltage charger detected

LED4 blinks twice per second Charging temperature is too low

LED4 blinks three times per second Charging temperature is too high

Always turn off the battery before inserting it or removing it from the Mavic Pro. Never insert or

remove a battery when it is turned on.

After these issues are resolved, press the Power Button to turn off the Battery Level Indicator. Unplug the

Intelligent Flight Battery from the charger and plug it back in to resume charging. You do not need to un-

plug and plug in the charger in the event of a room temperature error; the charger will resume charging

when the temperature is within the allowable range.

DJI does not take any responsibility for damage caused by third-party chargers.

How to discharge the Intelligent Flight Battery before transport the batteries for long trip:

Fly the Mavic Pro outdoors until there is less than 20% of power left, or until the battery can no

longer be turned on.