User Manual
Table Of Contents

©
 2017 DJI All Rights Reserved. 
25
Spark
User Manual
Video Recording
Perform the Video Recording gesture within 6 ft (2 
m) of the aircraft while facing toward the camera. 
The gesture has been recognized successfully if the 
Front LEDs blink red slowly. The Front LEDs will blink 
red quickly, indicating the camera is about to record 
video. Perform the record gesture again to stop.
Blinks red slowly
Beckon
1. Raise your arms above your head in a Y 
shape for two seconds after the aircraft starts 
tracking.
 —— 
Solid red 
2.  When Beckon is successfully activated, the 
aircraft will y toward you and hover in place 
1.5 m above ground and 1.2 m away from 
you.
3.  The front LEDs will turn solid red.
PalmLand
Face toward to the camera and place your palm 
approximately 0.5 m underneath the aircraft at a 
distance of no further than 1.5 m away from you. 
The aircraft will slowly descend and land on your 
palm. 
 —— 
Solid red 
0.3-0.5 m
It is highly recommended to install the Spark Propeller Guards before using Gesture Mode to 
ensure safety. 
Gesture Control needs to be enabled in DJI GO 4 by tapping   . The wave gesture is now 
disabled by default while ying indoors or where the GPS signal is weak to ensure safety.
In PalmLaunch,  the Aircraft Status Indicators will  blink normally and  will  not display remote 
signal loss, even without a mobile device or remote controller connected. 
Use Gesture Mode in open areas.
Gesture Mode can only be used to take photos.
Enabling GPS on your mobile device will allow the aircraft to follow more accurately in Gesture Mode.
In Gesture mode, the aircraft will descend automatically if there is no subject detected or the 
subject has been lost for more than one minute. Avoid using gesture control over water or 
drastically uneven ground.
Drag a box around the subject in DJI GO 4 to restart tracking if the subject was lost and the 
aircraft was unable to recognize the corresponding gesture.
Ensure the environment is suitable for the vision system to operate properly (e.g. light is 
sucient and the ground is clearly patterned or textured) if using Gesture mode indoors. 










