User Manual
RONIN-SC
User Manual
© 2019 DJI OSMO All Rights Reserved.
23
The Auto Tune process takes approximately 15 to 30 seconds. After Auto Tune, you can see detailed motor
diagnostics at the bottom of the screen. If the gimbal is properly balanced, the power value of the motors
should be in the range of ±5. If power consumption on a particular axis constantly goes beyond that range,
check the mechanical balance of Ronin-SC.
Stiffness: The motor stiffness adjustment allows you to ne-tune the power that is applied by the motors as
they react and balance the weight on each axis. Make sure you leave an extra margin to ensure stability
at all times. If the stiffness value is too high the gimbal may shake and if the value is too low the gimbal
performance will be affected.
When using Auto Tune, make sure the three axes are unlocked, and that Ronin-SC is placed on a
steady surface in Upright mode.
Make sure the gimbal is balanced and the stiffness values are tuned properly every time you
change the camera or lens.
User Prole
Three user proles can be set and save.
Gimbal Follow Mode
Pan and Tilt Follow: Pan and tilt axes follow the movement of the grip.
Pan Follow: Only pan axis follows the movement of the grip.
FPV: Pan, tilt and roll axes follow the movement of the grip.
Custom: Tap the blue arrows of the gure to manually set which axis will follow the movement of the grip.
3D Roll 360: Allows the camera to rotate 360° at any attitude.
Speed: Determines how fast the camera travels while translating a pan, tilt, or roll movement.
Deadband: The deadband determines how much movement the gimbal tolerates prior to translating the
pan, tilt, and roll movement of the camera.
Push: After enabling Push, the gimbal axis can be manually pushed to the desired position.