User Manual

©
2016 DJI All Rights Reserved.
19
MATRICE 600 PRO User Manual
P-mode (Positioning): P-mode works best when GPS signal is strong. There are several states in
P-mode which are automatically selected by the Matrice 600 Pro depending on GPS signal strength:
P-GPS: GPS is available. The aircraft uses GPS for positioning.
P-ATTI: GPS is not available. The aircraft only uses its barometer for maintaining altitude.
A-mode (Attitude): GPS is not used for positioning. The aircraft only uses its barometer to maintain
altitude. If it is still receiving a GPS signal, the aircraft will automatically Return-to-Home if the remote
controller signal is lost, and if the Home Point was recorded successfully.
F-mode (Function): Intelligent Flight Mode and API Control are supported in this mode. Refer to the
Intelligent Flight Modes (p. 47) section in the Appendix and SDK in DJI Assistant 2 (p. 30) for more
information.
The ight mode is locked in P-mode by default. To enable other ight modes, go to the DJI GO app >
Camera View > > Enable Multiple Flight Mode.
Landing Gear Control Switch
This switch has two positions. Toggle the switch up or down to raise or lower the landing gear.
1. Raise: Raise the landing gear to its upper most position. The landing gear will automatically raise
when the aircraft reaches an altitude of 1.2 m for the rst time.
2. Lower: The landing gear will lower to its lowest position for landing. The landing gear will
automatically lower if Auto-Landing is enabled in the DJI GO app or when the aircraft is landing
automatically as part of the RTH procedure.
Figure Flight Mode
P P-mode
A A-mode
F F-mode
Flight Mode Switch
Toggle the switch to select the desired ight mode.
You may choose between P-mode, A-mode and F-mode.
A
P
F
LowerRaise