User Manual

Table Of Contents

MATRICE 600 PRO

User Manual

Upgrading the Firmware

Upgrading the Aircraft and Lightbridge 2 Air System Firmware

Connect the aircraft to the DJI Assistant 2 to upgrade the aircraft’s and Lightbridge 2 Air System’s

rmware. Refer to DJI Assistant 2 (p. 30) for details.

Upgrading the Remote Controller Firmware

The System Status bar in Camera View of the DJI GO app will flash several times if a firmware

upgrade is available. Follow these steps to upgrade the rmware via the DJI GO app.

1. Go to the DJI GO app > Camera View > System Status bar > Overall Status. Tap Download

Firmware to download and upgrade the rmware.

2. A progress bar in the DJI GO app will indicate the upgrade status. The Status LED on the remote

controller will be solid blue while the upgrade is in progress and it will turn solid green when the

upgrade is successful. The LED will turn solid red if the upgrade fails. Restart the remote controller

and try again.

DO NOT perform the rmware upgrade while the aircraft is ying in the air. Only carry out

the rmware upgrade when the aircraft is on the ground.

Both the Lightbridge 2 Air System and the remote controller rmware must be up-to-date, or

else they will not link.

Check in the DJI GO app that you have the latest rmware installed before each ight.

The rmware upgrade requires an internet connection. Connect your mobile device to a Wi-Fi

network whenever possible.

DO NOT power off the remote controller during the upgrade.

The remote controller may become unlinked from the aircraft after the rmware upgrade.

Relink the remote controller and aircraft if necessary.

Upgrading the Zenmuse Z30, X3, X5 Series and XT Firmware

If you are using a Zenmuse Z30, X3, X5 series or XT gimbal and camera, mount the gimbal and

camera to the aircraft and follow the steps below to upgrade its rmware via a Micro SD card.

Be sure to unplug the gimbal attitude cable before camera firmware update, or else

rmware update will fail. Ensure that the aircraft is powered off before unplugging the cable.

Ensure that there is only one version of update le in the Micro SD card, or else there will be

an update error.

Step 1- Check the Battery Level and Micro SD Card Storage

a. Ensure that the Intelligent Flight Batteries have at least 50% power level. Power on one of the

batteries and ensure that other batteries are triggered automatically. If not, nd solutions in the DJI

GO app.

b. Ensure that there is at least 100MB of free space on the Micro SD card.

Step 2- Prepare the Firmware Update Package

a. Download the rmware update package from the Matrice 600 Pro page on the DJI website.

(http://www.dji.com/matrice600-pro/info#downloads)