User Manual
Ronin-M
User Manual
24
©
2015 DJI. All Rights Reserved.
Settings
Adjust the following basic functions before using the Ronin-M: Auto Tune Stability, Briefcase Mode,
SmoothTrack, and Maximum Speed Adjustment.
The denition and function of every button in the DJI Assistant App and DJI PC Assistant are the same,
refer to the section describing the DJI Assistant App for more details.
Basic
1. Gimbal
Motor: The Auto Tune Stability button allows for automatic adjustment of each motor’s stiffness settings
(as relayed from the sensors and interpreted by the Ronin-M) to accomplish an optimized setting.
Each axis has its own stiffness and trim adjustment.
Live Data: This monitors the feedback from the motors on each axis.
Briefcase Mode: Select the checkbox to enable Briefcase Mode.
EnableSilentMode:Select the checkbox to reduce motor noise.
Internal Receiver Off: Select to prevent the gimbal from being controlled by the included remote
controller or the optional thumb controller. The gimbal can then only be controlled by other devices via
a D-Bus or Lightbridge connection when the Internal Receiver is off.
Roll Remote Control Off: Select this checkbox to prevent the roll axis movement from being controlled
by the included remote controller or the optional thumb controller.
Motor Kill Switch: Select the checkbox to enable the Motor Kill Switch.
SmoothTrack: Select this checkbox to enable SmoothTrack. Note that the pan axis and the tilt axis can
be adjusted independently.
The pan and tilt SmoothTrack speed can be tested. Ensure that there is nothing obstructing the
camera when running the test procedures.
Reset Password: If you forgot your Bluetooth connection password, click here to reset your password.
Calibrate Center: If the Ronin-M’s pan axis is off center, you can recalibrate the true center of the
Ronin-M using this switch. Using a remote control, position the pan axis at dead center, then click the
Calibrate Center button. Click “Center” again in the pop-up to conrm.
DJI PC / MAC Assistant Tuning