User Manual

The Main Menu contains three tabs: Gimbal, Channel and Settings.

Press up/down on the thumb stick to select an item. Press right to view and

select options, and press left to return to the Main Menu.

Gimbal

Mode

ST Off: SmoothTrack is off. The Thumb Controller is free to control the pan axis.

The gimbal will stop and hold the last position determined by the pan axis control

stick, without applying SmoothTrack.

ST On: SmoothTrack is on. The Thumb Controller is free to control the pan axis.

The gimbal will stop and hold the last position determined by the pan axis control

stick, while applying SmoothTrack.

Auto Center: SmoothTrack is on. The gimbal will apply SmoothTrack when

reorienting and resetting the pan angle to the forward-facing direction after the

pan axis control stick is released.

Follow Speed

The Follow Speed tab allows you to select the SmoothTrack speed.

There are 3 possible speeds: Fast, Normal, and Slow. The value of each speed

can be adjusted in the DJI Assistant app or the PC/MAC Assistant.

Calibration

“Cali System” should be used if there is perceptible drift on any axis. The

calibration procedure should take approximately 90 seconds to complete.

Selecting “Auto Tune” will automatically adjust each motor’s stiffness settings

to achieve an optimal balance. This process should take approximately 20