User Manual

seconds to complete.

The gimbal cannot be controlled by the Thumb Controller or the remote controller

during calibration. Do not touch or move the gimbal during either process.

Channel

Mapping

Allows you to assign control of the pan, tilt, or roll motion of the gimbal to the up/

down or left/right input of the thumb stick.

By default, the up/down input on the thumb stick controls the tilt axis

movement of the gimbal and the left/right input on the thumb stick

controls the pan axis movement of the gimbal.

If you reassign the control input of either axis, only the most recent

assignment will be valid.

Direction

Under the ‘Normal’ setting, the gimbal moves in the same direction of the input

of the thumb stick. (Default settings: up/down tilt, left/right pan)

Selecting ‘Reverse’ for the up/down or left/right input will reverse the controls

respectively.

Settings

Sensitivity

There are two sensitivity settings for the Thumb Controller: High/Low.