Owner's Manual
DJI Air 2S User Manual
28
©
2021 DJI All Rights Reserved.
Using the Battery
Checking Battery Level
Press the power button once to check the battery level.
Powering On/O
Press the power button once, then press again, and hold for two seconds to power the battery on or
o. The battery level LEDs display the battery level when the aircraft is powered on.
Low Temperature Notice
1. Battery capacity is signicantly reduced when ying in low-temperature environments of 32° to 41° F (0°
to 5° C). It is recommended to hover the aircraft in place for a while to heat the battery. Make sure to
Battery Level LEDs
Power Button
LED1LED3
LED2
LED4
8. Short Circuit Protection: The power supply is automatically cut if a short circuit is detected.
9. Battery Cell Damage Protection: DJI Fly displays a warning prompt when a damaged battery cell is
detected.
10. Hibernation Mode: The battery switches o after 20 minutes of inactivity to save power. If the battery
level is less than 5%, the battery enters Hibernation mode to prevent over-discharge after being idle
for six hours. In Hibernation mode, the battery level indicators do not illuminate. Charge the battery
to wake it from hibernation.
11. Communication: Information about the voltage, capacity, and current of the battery is transmitted to
the aircraft.
Refer to the DJI Air 2S Disclaimer and Safety Guidelines and the battery sticker before use. Users
take full responsibility for all operations and usage.
Battery Level LEDs
: LED is on
: LED is ashing : LED is o
LED1 LED2 LED3 LED4
Battery Level
Battery Level ≥ 88%
75% ≤ Battery Level < 88%
63% ≤ Battery Level < 75%
50% ≤ Battery Level < 63%
38% ≤ Battery Level < 50%
25% ≤ Battery Level < 38%
13% ≤ Battery Level < 25%
0% ≤ Battery Level < 13%