Quick Start Guide

DJI RS 2

Quick Start Guide

To remove the lower quick-release plate, toggle the lever on the camera mounting plate

to the unlocked position and remove the lower quick-release plate while pressing the

safety lock on the mounting plate.

Balancing

Balancing is required before shooting. Before balancing, make sure to power on the camera

if using an optical zoom lens and to select the focal length if using a varifocal lens. Make sure

DJI RS 2 is powered off or in sleep mode before balancing.

1. Balancing the Vertical Tilt

a. Unlock the tilt axis and loosen the mounting plate knob

b. Rotate the tilt axis so that the camera lens is pointing upward. Check to make sure

the camera is not top or bottom-heavy. If top-heavy, move the camera backward

. If

bottom-heavy, move the camera forward

c. Tighten the mounting plate knob while holding the camera upward. The vertical tilt is

balanced when the camera is steady while pointing upward.

4. Connect the Camera Control Cable

Choose the proper camera control cable according to the camera type. Plug one end

of the cable into the RSS camera control port of the gimbal (shown above) and plug the

other end into the camera.

Safety Lock

RSS Camera Control Port