User Manual

16
©
2017 DJI All Rights Reserved.
Upgrading Firmware
DJI Assistant 2
Use DJI Assistant 2 to upgrade the Goggles.
1. Power on the Goggles and connect them to a computer with a Micro USB cable.
2. Launch DJI Assistant 2 and login with a registered DJI account.
3. Select “Goggles” and click “Firmware Upgrade” on the left-hand side.
4. Select the rmware version required.
5. DJI Assistant 2 will download and upgrade the rmware automatically.
6. Restart the Goggles after the rmware upgrade is complete.
Use DJI Assistant 2 to upgrade the aircraft and remote controller of the Mavic Pro and the Goggles
simultaneously (only supports connection topology for Standard Mode).
1. Ensure all devices are powered on and that the aircraft is linked with the remote controller.
2. Connect the remote controller to a computer with a Micro USB cable.
3. Launch DJI Assistant 2 and login with a registered DJI account.
4. Select “RC for Mavic Pro” and click “Firmware Upgrade” on the left-hand side.
5. Select the required rmware version.
6. DJI Assistant 2 will download and upgrade the rmware automatically.
7. Restart all devices when the rmware upgrade is complete.
DJI GO 4 App
Use the DJI GO 4 app to upgrade the aircraft and remote controller of the Mavic Pro and the
Goggles simultaneously (only supports connection topology for Standard Mode).
1. Ensure all devices are powered on and that the aircraft is linked with the remote controller.
2. Connect the remote controller with the DJI GO 4 app. A prompt will appear if a new rmware
upgrade is available. To start upgrading, connect a mobile device to the Internet and follow the
on-screen instructions.
3. Restart all devices when the rmware upgrade is complete.
Cleaning and Maintenance
Be sure to unplug the charger from the power outlet before cleaning and ensure that there are no
cables connected.
Cleaning the Goggles
Wipe and clean the surface of the Goggles with a soft clean cloth.
When cleaning the facial pad, lift and remove it from the nose part. Clean the facial pad with water,
DO NOT charge the Goggles when it is powered on to ensure safety.
When using a non-standard charger, the maximum output voltage must not exceed 12 V.
The Goggles battery is located in the headband. You can connect the headband individually
to the charger for charging. The battery is fully charged when the charging status indicator
turns off.
A standard charger is recommended for charging. It takes approximately four hours to
fully charge the battery. Other chargers may take longer.