Manual

Table Of Contents

Tools Needed

2.0mm Hex Wrench

For frame and motors installation.

Screw Glue

For fastening screws.

Nylon Cable Tie

For binding devices and wires.

Scissors

Diagonal Cutting Pliers

Foam Double Sided Adhesive Tape

For fixing receiver, controller and other modules.

Soldering-iron & wires

For connecting ESCs’ power cables to bottom board.

ESC Wiring

ESC

To Battery

Power Pads

Important

 Please solder ESCs to power pads on bottom board as the figure shows.

 Use any insulating method at all soldering spots. Make sure there is no short or open circuit.

 Make sure the side of power pads is upward.

 Make sure the rotation direction of each motor is the same as the way in the figure of

“Assembly” shows. If not, switch any of two wire connetcions of the incorrect motor to change

its rotation direction.