User manual

34
©
2017 DJI. All Rights Reserved.
INSPIRE 1 PRO User Manual
Status LED Alarm Remote Controller Status
— Solid Red chime
The remote controller set as "Primary" but it is
not connected with the aircraft.
— Solid Green chime
The remote controller set as "Primary" and it is
connected with the aircraft.
— Solid Purple D-D-
The remote controller set as "Secondary" but it
is not connected with the aircraft.
— Solid Blue D-D- chime
The remote controller set as "Secondary" and it is
connected with the aircraft.
Slow Blinking Red D-D-D
......
Remote controller error.
/
Red and Green/ Red and
Yellow Alternate Blinks
None HD Downlink is disrupted.
RTH LED Sound Remote Controller Status.
— Solid White chime Initiate RTH procedure.
Blinking White D
. . .
Send RTH command to aircraft.
Blinking White DD
.. .. ..
Aircraft returning to Home Point.
The Remote Status Indicator will blink red, sound an alert, when the battery level is critically low.
Linking the Remote Controller
The remote controller is linked to your aircraft before delivery. Linking is only required when using a new
remote controller for the rst time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect to the mobile device. Launch DJI GO app.
2. Power on the Intelligent Flight Battery.
3. Enter “Camera” view and tap on and then tap “Linking Remote Controller” button as shown below.
RC Control Setting
Remote Control Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking Remote Controller