User manual

8
©
2017 DJI. All Rights Reserved.
INSPIRE 1 PRO User Manual
To remove the camera lens, power off the battery and then:
1. While holding down the Lens Release Button, rotate the Lens Lock clockwise to unlock it.
2. While holding down the Lens Release Button, rotate the camera lens counterclockwise to detach it.
Lens Release Button
It is recommended to wrap a dust cover around the lens to prevent contamination. DJI
produces dedicated dust covers for the DJI MFT 15mm f/1.7 ASPH and the Panasonic
Lumix G Leica DG Summilux 15mm f/1.7 ASPH. Other lenses may require you to purchase
a third-party dust cover.
It is important to tighten the Lens Lock after attaching the camera lens, as this can reduce the
vibrations of the lens when the aircraft is moving in ight. Always loosen the Lens Lock before
attaching and detaching the camera lens.
A lter can be installed in place of the Camera Balancing Ring. Remember to use a lter that
fullls the weight requirement.
Some lenses must not be used with a lens hood. Be sure to check the table above for
accessory requirements for your lens.
Be sure to set the lens to AF mode.
Always hold down the Lens Release Button before rotating the Lens Lock to unlock it.
Lens Hood
Balancing Ring (or Filter)
6
7
Micro-SD
Click
5
4
4. Align the two Lens Mount Indexes on the camera body and camera lens, and insert the camera lens
into the body of the camera.
5. Rotate the camera lens clockwise until you hear a click.
6. Rotate the Lens Lock counterclockwise to lock it.
7. Mount the Balancing Ring (or a lter) and the Lens Hood.
8. Insert the Micro SD card.