Operation Manual

User Manual

INSPIRE RAW

Model DJI Balancing Ring

Filter

Lens Hood

Thread Size Weight

DJI MFT 15mm f/1.7 ASPH BR-Φ46-10 46 mm 10 g Required

Panasonic Lumix G Leica DG

Summilux 15mm f/1.7 ASPH

BR-Φ46-10 46 mm 10 g Required

Olympus M.Zuiko Digital ED 12mm f/2.0 BR-Φ46-10 46 mm 10 g Not required

Olympus M.Zuiko Digital ED 17mm f/1.8 BR-Φ46-33 46 mm 33 g Not required

Olympus M.Zuiko Digital ED 25mm f/1.8 Not required 46 mm 10 g Not required

Olympus M.Zuiko Digital ED 45mm f/1.8

(For still photography)

Not required 37 mm 14 g Not required

Olympus M.Zuiko Digital

ED 14-42mm f/3.5-5.6 EZ

(For still photography)

BR-Φ37-23 37 mm 23 g Not required

The thread size and weight of the Balancing Ring are included in the model number (i.e. BR-Φ46-10 has

a thread size of 46 mm and a weight of 10 g).

The Balancing Ring must be installed on the camera lens when a lter is not used.

Supported Micro SD Cards

The Zenmuse X5R comes with a 16GB Micro SD card, but also supports Micro SD cards with a capacity

of up to 64GB. We recommend using a UHS-1 Micro SD card to minimize the delay when reading and

writing high resolution video data.

DO NOT remove the Micro SD card from the Zenmuse X5R when it is powered on.

Supported X5R SSD

The Zenmuse X5R comes with an integrated 512GB X5R SSD for storing lossless and uncompressed

footage. Note that its operating temperature is 32° to 158° F (0° to 70° C).

Installing the Camera Lens

The following steps use the DJI MFT 15mm f/1.7 ASPH as illustration of how to mount the camera lens to

the camera body. Be sure to power off the battery before installation.

1. Remove the camera body cap.

2. While holding down the Lens Release Button, rotate the Lens Lock clockwise to unlock it.

3. Remove the lens cap and rear cap.

Lens Release Button