Operation Manual

Product Profile

INSPIRE 1

User Manual

Battery must be fully charged before using it for the rst time. Refer to "Charging the Intelligent

Flight Battery" (P21) for more information .

If you have purchased the dual remote controller version, you must use the Master remote

controller to deactivate Travel Mode. Refer to "Setting Up Dual Remote Controllers Mode" (P30)

section for more infromation about Master remote controller.

Be sure to remove the gimbal from the aircraft before switch from Landing Mode to Travel Mode.

Place the aircraft on the smooth and reective surface (e.g. table or tile) before switching between

the travel modes to the landing mode. Do not place the aircraft on the rough and sound-absorbing

surface (e.g. carpet) before switching between the travel modes and landing mode.

Installing Gimbal and Camera

1. Remove Gimbal Cover.

2. Rotate the Gimbal Lock to the unlocked position (to the right when facing the nose of the aircraft).

3. Insert the gimbal by aligning the white mark on the Gimbal.

4. Rotate the Gimbal Lock back into the locked position.

Ensure the Micro-SD card is correctly inserted into the camera.

Locked

Gimbal Connector

Mounting Place

Gimbal Lock

Gimbal Cover

Attaching Propellers

Attach propellers with the black nut onto motors with the black dot and spin counter-clockwise to secure.

Attach propellers with gray nut onto motors without a black dot and spin clockwise to secure.