User manual
Table Of Contents
36
©
2016 DJI. All Rights Reserved.
DJI MATRICE 100
User Manual
Master Remote
Controller
Slave Remote
Controller
Use the gimbal dial on the remote controller to tilt the camera in the Single Remote Controller
mode. However, you cannot pan the camera.
Setting Up Dual Remote Controllers Mode
The Dual Remote Controllers mode is disabled by default. Users must enable this feature on the
Master Remote Controller through the DJI GO app. Follow the steps below for setup:
Master Remote Controller:
1. Connect the remote controller to your mobile device and launch the DJI GO app.
2. Go to the Camera View, and tap
to enter the remote controller settings window.
3. Select Master in the Set RC Status section to set the remote controller as the Master remote
controller.