User manual

©
2016 DJI. All Rights Reserved.
39
DJI MATRICE 100 User Manual
Status LED Alarm Remote Controller Status
— Solid Red chime
The remote controller is set as Master but is not
connected to the aircraft.
— Solid Green chime
The remote controller is set as Master and
connected to the aircraft.
— Solid Purple D-D-
The remote controller is set as Slave but is not
connected to the aircraft.
— Solid Blue D-D-
The remote controller is set as Slave and
connected to the aircraft.
Blinking Red Slowly D-D-D
......
Remote controller error.
/ Red and Green/
Red and Yellow Alternate Blinks
None HD Downlink is disrupted.
RTH LED Sound Aircraft Status
— Solid White chime Return-to-Home procedure is activated.
Blinking White D
. . .
Sending Return-to-Home command to the aircraft.
Blinking White DD
.. .. ..
Return-to-Home is in progress.
When the battery level is critically low, the Remote Controller Status LED will blink red and
sound an alert.
Linking the Remote Controller
The remote controller is linked to your aircraft by default. Linking is only required when a new remote
controller is used for the rst time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect it to your mobile device.
2. Power on the Intelligent Flight Battery.
3. Launch the DJI GO app. Go to the DJI GO app > Camera View >
> RC Control Settings >
Linking RC.
RC Control Settings
RC Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking RC