User manual

40
©
2016 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
RC Control Settings
RC Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking RC
C2
Searching for aircraft frequency,
timeout in 54 seconds
Cancel
Press the linking button on the aircraft
to link this remote controller
4. The Remote Controller Status LED will blink blue and emit a ‘beep’ sound to indicate that the
remote controller is ready to be linked.
5. Press the red Linking Button besides the ight controller (shown in the gure) to begin linking.
The Remote Controller Status LED will glow solid green if linking is successful.
The remote controller cannot link to the aircraft or control aircraft movement if it is set to
Slave. Set the remote controller as Master in the DJI GO app if you want to link the remote
controller to the aircraft.
The remote controller will disconnect from the linked aircraft if another remote controller
attempts to link to the same aircraft.
Remote Controller Compliance
The remote controller is compliant with CE and FCC standards.