User manual

58
©
2016 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
Do NOT perform the CSC command when the aircraft is in mid-air.
Flight Test
Takeoff / Landing Procedures
1. Place the aircraft on an open, at ground with the battery indicator facing you.
2. Power on the remote controller and your mobile device, and then the Intelligent Flight Battery.
3. Launch the DJI GO app and enter Camera View.
4. Wait until the Aircraft Status Indicator ashes green. This means the Home Point is recorded and it
is safe to y. If it ashes yellow, the Home Point has not been recorded and you should not take off.
5. Push the throttle stick up slowly to take off or use Auto Takeoff.
6. To land, hover over a level surface and gently pull down on the throttle stick to descend slowly.
7. After landing, execute the CSC command or push the throttle stick down for 3 seconds until the
motors come to a stop.
8. Turn off the Intelligent Flight Battery, followed by the remote controller.
When the Aircraft Status Indicator flashes yellow rapidly during flight, the aircraft has
entered the Failsafe mode.
The Aircraft Status Indicator will ash red slowly for a Low Battery Level warning, and ash
red rapidly for a Critically Low Battery Level warning during ight.
OR