User manual

64
©
2016 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
Remove the propellers before upgrading the rmware to prevent injuries.
DO NOT start the motors or touch the motors when upgrading.
The remote controller may become unlinked from the aircraft after upgrading the
rmware. Re-link if necessary.
It is normal for the aircraft to make sounds or ash its LEDs when upgrading to indicate
the upgrade status.
Your Micro SD card should only contain one rmware update package.
Storage devices must be formatted with the FAT32 or exFAT le system.
Upgrading the Remote Controller Firmware
The System Status bar in the DJI GO app (center top of the camera view screen) will ash several
times if a rmware upgrade is available.
Step 1- Check your devices
Make sure:
- Remote controller has at least a 50% charge..
- Mobile device is connected to the internet.
- Mobile device has 30 MB of free space.
Step 2- Run the upgrade
1. Launch DJI GO and tap through “Camera View > System Status Bar > Overall Status”.
2. Tap “Download Firmware” to download the package and upgrade the rmware.
If the rmware upgrade fails, check the connection between the remote controller and your mobile
device, and then try again. Contact DJI Support if the problem persists.
(http://www.dji.com/support)
DO NOT perform rmware upgrades when the aircraft is airborne.
The remote controller may become unlinked from the aircraft after upgrading the
rmware. Re-link if necessary.
Ensure that your internet connection is stable before downloading the package.