User manual

70
©
2016 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
Under the default settings, turn the gimbal dial on the remote controller to tilt the camera. Note that
you cannot simultaneously tilt and pan the camera in the Single Remote Controller mode. Enable the
Master-and-Slave mode in the DJI GO app and set a second remote controller to Slave if you wish to
tilt and pan the camera together.
Gimbal Dial Settings
Follow the instructions below to use the gimbal dial to tilt/pan the camera:
1. Power on the aircraft and the remote controller.
2. Go to the DJI GO app > Camera View > Tap
> Tap RC Control Settings.
3. Set the customizable button C1 or C2 as the Gimbal Pitch/Yaw.
Press the C1 or C2 button to switch between pitch mode and yaw mode. Use the gimbal dial to
control the tilt/pan motion of the camera.
Using the DJI GO App to Control the Gimbal
Follow the steps below to use the DJI GO app to control the gimbal’s pitch/yaw motion:
1. Go to the DJI GO app > Camera View.
2. Tap and hold on the screen until a blue circle appears.
3. Move your nger to control the gimbal’s pitch/yaw motion.
RC Control Settings
RC Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking RC
Safe to Fly (GPS)
CL
P-GPS
1/320
4821
JPEG
ISO 100
EV 0
H: D:
V.S
M/S
M/S
H.S
4.22.3
39M 210M
232M