User manual

©
2016 DJI. All Rights Reserved.
73
DJI MATRICE 100 User Manual
DJI Guidance System Mounting Warning
1. If you mount the Guidance Sensors directly under the battery compartment, disconnect the cable
of the rear facing Guidance Sensor before accessing the Intelligent Flight Battery.
2. If you mount the side Guidance Sensors above the center frame, ensure they are mounted at least
8 cm (by stacking three expansion bays or one battery compartment with two expansion bays)
above the center frame, so that the propellers will not obstruct them. Be sure to mount the down
facing Guidance Sensor under the aircraft. Finally, mount the GPS mount on top of the expansion
bay using two M3x8 screws.
3. If you are using the DJI Zenmuse X3 Gimbal and Camera and the DJI Guidance system together,
be sure to mount the side Guidance Sensors above the center frame, otherwise you will be unable
to mount the front facing Guidance Sensor.
>8cm
DJI N1 Video Encoder
The N1 Video Encoder is intended for the Matrice 100 and DJI N1 Flight Controller, for which it offers
video signal transmission and firmware upgrade capabilities if you are not using the Zenmuse X3
Gimbal and Camera as your recording device.
The AV or HDMI port on the encoder receives video input from the non-DJI camera to generate a live
HD video feed in the DJI GO app. In addition, users may utilise the Micro USB port on the encoder to
upgrade the rmware of various modules on the Matrice 100.
Refer to the
N1 Video Encoder User Manual for details.
(http://www.dji.com/product/matrice100/info#downloads)