User manual

©
2016 DJI. All Rights Reserved.
7
DJI MATRICE 100 User Manual
Curved Fastener: Fix on the inner arm slot.
0° Fastener: Fix on the outer arm slot so that the propeller rotation plane is perfectly horizontal.
3° Fastener: Fix on the outer arm slot so that the propeller rotation plane is at a 3° incline. It is
recommended to use the 3° fasteners for a better ight experience.
1) Loosen the four M2.5x5 screws on the curved fastener and the 3° fastener on each of the frame arms.
2) Insert each frame arm into the outer and inner arm slots successively until the clamp ring reaches
the outer arm slot.
3) Rotate the frame arm so that the n on the clamp ring ts perfectly into the slot of the 3° fastener.
Then tighten the four screws to x the curved fastener and the 3° fastener in place. Ensure the
arrow on the 3° fastener is pointing upwards.
If you choose to use the 0° fasteners, remove the 3° fasteners from the arm slots rst. Ensure
that all propeller rotation planes are perfectly horizontal after mounting the 0° fasteners.
Do NOT mix up the 0° fasteners and the 3° fasteners. Ensure that the four fasteners on the
outer arm slots are the same.
The 3° Fastener (with marking) The 0° Fastener
Clamp Ring
Inner Arm Slot
Outer Arm Slot