User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Components at the Rear of the Aircraft
- DJI AirSense
- D-RTK (for M210 RTK V2)
- DJI Intelligent Flight Battery
- Spotlight Pro
- Center of Gravity Calibration
- Flight Recorder
- Return-to-Home (RTH)
- Vision System and Infrared Sensing System
- Flight Status Indicator
- Flight Mode
- Profile
- Attaching and Detaching the Propellers
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
©
2019 DJI All Rights Reserved.
39
MATRICE 200
SERIES V2 User Manual
Charging the Battery
The remote controller is powered by a WB37 intelligent battery, which can be charged via the
charging port or by the WCH2 Intelligent Battery Charging Hub.
Using the Charging Port
Place the battery into the remote controller, and connect connector B of the battery power port, then
connect the battery charger to a power outlet (100-240V, 50/60Hz). When charging is complete, the
display on the remote controller will show 100%.
B
B
A
Power Qutlet
100~240 V
Charging Time: 2 hours
Using the Charging Hub
Place the battery into the Charging Hub, and connect connector B of the battery charger to
the charging hub, then connect the battery charger to a power outlet (100-240V, 50/60Hz). The
Charging Hub will intelligently charge batteries in sequence according to battery power levels from
high to low. The buzzer will begin beeping when charging is complete. Remove the battery or turn
off the Buzzer Switch to stop it.
The charging hub blinks green while charging and turns solid green when charging is nished.
B
A
B
Power Qutlet
100~240 V
Using the WCH2 Charging Hub, charging time is approximately 1 hour and 11 minutes (for one battery).
Place the battery into the Charging Hub, and connect connector B of the battery charger to
the charging hub, then connect the battery charger to a power outlet (100-240V, 50/60Hz).
USB power supply port can be used to charge the mobile device of 5V/2A.
Refer to the WCH2 Charging Hub User Guide for more details.
B