User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Components at the Rear of the Aircraft
- DJI AirSense
- D-RTK (for M210 RTK V2)
- DJI Intelligent Flight Battery
- Spotlight Pro
- Center of Gravity Calibration
- Flight Recorder
- Return-to-Home (RTH)
- Vision System and Infrared Sensing System
- Flight Status Indicator
- Flight Mode
- Profile
- Attaching and Detaching the Propellers
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
©
2019 DJI All Rights Reserved.
69
MATRICE 200
SERIES V2 User Manual
Starting/Stopping the Motors
Starting Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors start spinning, release both sticks simul-
taneously.
OR
Stopping the Motors
There are two ways to stop the motors:
1. When aircraft has landed, push the left stick down
, then conduct the same CSC that was used
to start the motors, as shown above
. Motors will stop immediately. Release both sticks once
motors stop.
OR
Method 1 Method 2
Stop the Motor Mid-ight
To stop the motors mid-ight, press the RTH button while simultaneously pulling the left stick to the
bottom inner corner.
Stop motors mid-ight will cause the aircraft to crash. The motor can only be
stopped mid-ight when the ight controller detects critical error.
2. When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.