User manual

26
©
2018 DJI All Rights Reserved.
MATRICE 200 SERIES User Manual
Landing Protection will not be active in the following circumstances:
When the user is controlling the pitch/roll/throttle sticks (Landing Protection will re-activate
when the control sticks are not in use)
When the positioning system is not fully functional (e.g. drift position error)
When the downward vision system needs re-calibration
When light conditions are not sufcient for the downward vision system
If an obstacle is within one meter of the aircraft, the aircraft will descend to 0.7m above the
ground and hover. The aircraft will land after user conrmation.
Intelligent Flight Modes
The aircraft supports Intelligent Flight Modes*, including TapFly, ActiveTrack, and Tripod Mode. Tap
in DJI GO 4 or press the Function button on the remote controller to enable an Intelligent Flight Mode.
* Intelligent Flight Modes are not supported to use with the dual downward gimbals.
Zenmuse X4S or X5S is required when using the ActiveTrack. ActiveTrack is not supported when using the
Z30, XT and XT 2.
TapFly
Introduction
With the TapFly feature, users can now tap on the mobile device screen to y in the designated direction
without using the remote controller. The aircraft will automatically avoid obstacles it sees or brake and
hover in front of them, provided that there is sufcient light between (< 300 lux) and (> 10,000 lux).
Using TapFly
Ensure that the Intelligent Flight Battery is fully charged and the aircraft is in P-mode. Follow the
steps below to use TapFly:
1. Take off and ensure the aircraft is hovering at least 6 ft (2 m) above ground.
2 meters
2. Launch DJI GO 4 and tap , Select TapFly, then follow the prompts.
09:29
AE
P-GPS
AF/ MF
ISO
SHU TTER
EV
200 0.3
F
5.61/200 20:12
SD TIME
4KP30
74%
70%
4.07V
4.07V
In Flight (GPS)
5000K
WB
Custom
12
H 10.0 mD 30 m
VS 2.0 m/s VPS 2.0mH.S 10.0 km/h