User manual

Table Of Contents

MATRICE 200

SERIES User Manual

50%~63%

38%~50%

25%~38%

13%~25%

0%~13%

D-RTK and Datalink Pro

Introduction

For the M200 series, you can only activate D-RTK and Datalink Pro with the M210 RTK. Be sure to

activate both with DJI Assistant 2 before rst time use.

Using dual antennas, D-RTK provides more accurate heading data than a traditional single antenna

system, and it can withstand magnetic interference from metal structures. Depending on the region

of purchase, the D-RTK uses either GPS and BeiDou or GPS and GLONASS to perform at the

highest standards. The Datalink Pro is used to transmit the real-time data wirelessly.

Both D-RTK and Datalink Pro are composed with the air system and ground system. It is

recommended to use them in an open environment free from radio interference. Ensure the

antennas are unobstructed when in use. This manual uses the Datalink Pro 900 as an example.

Please refer to the D-RTK and Datalink Pro user guides for more details.

Activating D-RTK and Datalink Pro

IMPORTANT: The Ground System and Air System of both D-RTK and Datalink Pro should be

connected to the computer separately and activated. Be sure to configure parameters with DJI

Assistant 2 for rst time use.

1. Download DJI Assistant 2 from www.dji.com and install it on your computer.

2. Connect the aircraft to the computer and toggle the USB Mode Switch to the RTK position to

activate the D-RTK air system.

3. Connect the D-RTK Ground System to the computer with DJI Assistant 2 launched for activation.