User manual

Table Of Contents

Remote Controller

Remote Controller Prole

The Cendence

remote controller features DJI’s Lightbridge technology for a maximum transmission

distance of up to 4.3 mi (7 km).* Equipped with a DJI CrystalSky

7.85 inch monitor, which offers an HD

live camera view with its built-in DJI Pilot app or DJI GOTM 4 app for a precise and responsive ying

experience. Dual transmission frequency support makes HD video downlink stable and reliable. In Dual

Remote Controller mode, two remote controllers can control the aircraft and camera separately and

simultaneously. Dual Remote Controller mode even works when users are up to 328 ft (100 m) apart.

The remote controller works with a WB37 intelligent battery, which can be charged via the charging

port (in about 2 hours and 24 minutes with a 180W charger) or with the WCH2 Intelligent Battery

Charging Hub (in about 1 hour and 11 minutes). The maximum operation time of the remote controller

is approximately four hours without supplying power to a monitor and with the Dual Remote Controller

mode disabled.*

With various customizable buttons, you can adjust a number of ight controller, camera, and gimbal

parameters with just your hands. The Cendence Patch Antenna also allows for high-gain signal

transmission and improved reception.

* The remote controller can reach its maximum transmission distance (FCC) in a wide open area with no

electro-magnetic interference at an altitude of about 400 feet (120 meters).

To comply with local regulations, the 5.8 GHz frequency is not available in some countries and regions.

Maximum run time is estimated without supplying power to a smart device or monitor.

Compliance Standards: The remote controller is compliant with local laws and regulations.

Stick Mode: Controls can be set to Mode 1, Mode 2, or to a custom mode.

Mode 1: The right stick serves as the throttle.

Mode 2: The left stick serves as the throttle.

Please refer to the CrystalSky User Guide for more CrystalSky details.

Do not operate more than three aircraft within the same area (roughly the size of a soccer

eld) to prevent transmission interference.

Preparing the Remote Controller

Mounting/Removing the Intelligent Battery

Put the battery into the Battery Slot, then slide it to the end until you hear a click.

Press the Battery Release Button before removing the battery.

Press the Battery Level Button once to check the battery level.