User manual

52
©
2018 DJI All Rights Reserved.
MATRICE 200 SERIES User Manual
Conguring the Customizable Buttons
Go to the Customizable Button Settings Menu in DJI GO 4. Here you can set functions for the left
lever, right lever, C1-C4 buttons, and BA-BH buttons.
Dual Remote Controller Mode
More than one remote controller can connect to the same aircraft in Dual Remote Controller mode.
The primary remote controller operator controls the orientation of the aircraft, while the secondary
remote controller controls the movement of the gimbal and camera operation. Primary and
secondary remote controllers communicate each other via Wi-Fi.
In Dual Controller Mode, when the primary remote controller is primary, it can control
gimbal pitch and pan. When the secondary remote controller is primary, it can control
gimbal pitch, pan, and roll.
Dual Remote Controller mode is not available in Russia and Israel.
Setting Up Dual Remote Controller Mode
Dual Remote Controller mode is disabled by default. Users must enable this feature on the primary
remote controller via DJI GO 4. Follow the steps below to setup:
Primary Remote Controller:
1. Connect the remote controller to your mobile device and launch DJI GO 4.
2. Go to the Camera View and tap
to enter the remote controller settings window.
3. Select primary and set the remote controller as the primary remote controller.
4. Enter the connection password for the secondary remote controller.
Primary
Primary ID: 28172d Secondary ID: 14f93f
Connection Status:ON Authorization Code:
Set Remote Controller Status
Primary and Secondary
Remote Controller Calibration
666666
Remote Controller Settings
Secondary
OFF