User manual

Table Of Contents

MATRICE 200

SERIES User Manual

7. Mount the dual downward gimbal connector to the aircraft.

Using the Dual Downward Gimbals

All Zenmuse X5S, X4S, XT, XT 2, and Z30 gimbals are supported. You can mount them to the

Gimbal Connector I and Gimbal Connector II as shown below:

Gimbal Connector II Gimbal Connector I

Zenmuse XT Zenmuse X4S/X5S/Z30/XT 2

Zenmuse Z30 Zenmuse X4S/X5S/XT/XT 2

Gimbal

Connector II

Gimbal

Connector I

Please note that Gimbal Connector II can be mounted with the Zenmuse XT and Z30 only. Gimbal

Connector I and Gimbal Connector II cannot be mounted with two of the same Zenmuse gimbals.

Gimbal Connector I's camera view will show on the main interface in the DJI Pilot app, while Gimbal

Connector II's camera view will show on the assistant interface. You can switch between them.

If using only one camera be sure to install the gimbal and camera on Gimbal Connector I

and not on Gimbal Connector II.

Single upward gimbal connector and dual downward gimbal connector should be used

separately. DO NOT use them at the same time.