User manual

88
©
2018 DJI All Rights Reserved.
MATRICE 200 SERIES User Manual
Mount the GPS module.
Remove the D-RTK
antenna from the
aircraft’s left side and
mount the GPS module.
Connect the GPS module
to the CAN Bus Port (in
the expansion ports)
ensuring that the side
with the arrows is facing
upward.
Connect the GPS module
to the CAN Bus Port (in
the expansion ports)
ensuring that the side
with the arrows is facing
upward.
Mount the
upward gimbal,
and connect it to
the DGC2.0 port.
Mount the
upward gimbal,
and connect it to
the DGC2.0 port.
Make sure you secure the GPS module and upward gimbal’s cables with the cable clamps for
safety.
Note that the whole aircraft will not retain its IP43 rating if the GPS module is installed.
Single upward gimbal connector and dual downward gimbal connector should be used
separately. DO NOT use them at the same time.
DO NOT try to remove the GPS antenna without rst removing the four screws that hold it in place
as doing so could damage the antenna.
Follow the steps below to mount the Upward Gimbal and GPS Module on the M210:
Follow the steps below to mount the Upward Gimbal and GPS Module on the M210 RTK: