User manual
Table Of Contents
- Using This Manual
- Product Profile
- Flight Safety
- Aircraft
- Remote Controller
- Starting and Activating the Remote Controller
- Remote Controller Overview
- Mounting the WB37 Intelligent Battery
- Mounting the Dongle
- Mounting the Strap and Bracket Kit
- Adjusting the Antennas
- IP Rating
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Advanced Dual Operator Mode
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Pilot 2 App
- Firmware Update
- Appendix
93
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
b. When the aircraft is in vision positioning, standby, or manual ight status, the current ight
mode will be displayed, including: N-mode, S-mode, A-mode, and T-mode.
c. Tap to enter Preight Check view.
4. Intelligent Flight Battery Level Indicator: The battery level indicator bar provides a dynamic display of
the remaining power of the current intelligent ight battery and the ying time. Each battery state is
indicated by a dierent color. When the battery level is lower than the warning threshold, the battery
icon on the right turns red, reminding the user to land the aircraft as soon as possible and replace
the batteries.
5. GNSS Positioning Status: displays the number of GNSS satellites. When the aircraft RTK module is
disabled, the RTK icon will turn gray; when it is enabled, the RTK icon will turn white. Tap the GNSS
positioning status icon to view the status of the RTK mode and GNSS positioning.
6. Signal Strength: includes HD video link quality and remote controller link quality. Three green dots
indicate strong signals; two yellow dots for medium signal strength; and one red dot for poor signal
quality. If the signal is lost, the icon will display a disconnected status in red.
7. Intelligent Flight Battery Level: displays the remaining battery level of the aircraft. Tap to view battery
level, voltage and temperature information.
8. Settings: Tap to expand the settings menu to set the parameters of each module.
a. Flight Control System Settings: include ight mode switch, Home Point, return to home
altitude, maximum altitude, distance limit, sensor status, out-of-control action, coordinated
turn, and GNSS.
b.
Sensing System Settings: include obstacle sensing switch, vision positioning switch,
and precision landing switch.
c.
Remote Controller Settings: include stick mode, customizable button settings, and
remote controller calibration and linking.
d. Video Transmission Settings: include work frequency, channel mode, and video output
type.
e.
Intelligent Flight Battery Settings: include battery information, smart return-to-home, low
battery warning thresholds, and number of days required for self-discharge.
f.
Gimbal Settings: include gimbal pitch and pan settings, and gimbal auto calibration.
g.
RTK Settings: include the RTK positioning function, RTK service type, and their
corresponding settings and status displays.
h.
General Settings: include map selection, track display, unit setting, and lights setting.