User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Profile
- Flight Mode
- Flight Status Indicator
- Aircraft Beacons
- Aircraft Auxiliary Lights
- Vision System and Infrared Sensing System
- Return-to-Home (RTH)
- Center of Gravity Calibration
- Flight Recorder
- Propellers
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Intelligent Flight Battery Functions
- D-RTK
- DJI AirSense
- Expansion Ports
- IP45 Protection Rating
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
©
2020 DJI All Rights Reserved.
33
MATRICE 300 RTK User Manual
Battery Station Firmware Update
Use the DJI Pilot App to update rmware of the Battery Station as well as up to 8 TB60 ight batteries
at the same time.
1. Insert the batteries into the Battery Ports and turn on the Battery Station.
2. Connect the Battery Station to the remote controller using a USB-C cable.
3. Turn on the remote controller and make sure it is connected to the Internet.
4. Run the DJI Pilot app, tap to enter PILOT page. If it shows that there is a rmware update for the
Battery Station, then tap into the HMS page.
5. Tap to enter the rmware update page.
6. Tap the update all button and wait for about 10 minutes to complete the rmware upgrade.
During rmware update, do not insert or remove the battery to avoid battery update failure.
During rmware update, do not unplug the USB-C cable to avoid battery update failure.
During rmware update, do not charge the battery station.