User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Profile
- Flight Mode
- Flight Status Indicator
- Aircraft Beacons
- Aircraft Auxiliary Lights
- Vision System and Infrared Sensing System
- Return-to-Home (RTH)
- Center of Gravity Calibration
- Flight Recorder
- Propellers
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Intelligent Flight Battery Functions
- D-RTK
- DJI AirSense
- Expansion Ports
- IP45 Protection Rating
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
58
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Battery Level Indicators Battery Level
75%~100%
50%~75%
25%~50%
0%~25%
Smart Controller Warning Sounds
In certain scenarios that require a user warning, the Smart Controller will do so by vibrating and/or
beeping. When the controller beeps and the status LED is solid green, this error may be related to
the aircraft or ight status, and a warning will appear in DJI Pilot. If this error is related to the Smart
Controller, the controller’s screen will display a warning or alert.
To disable the beeping, power on the remote controller, select “Sound” in Settings, and turn off
“Notication volume”.
Some prompts or warning sounds cannot be turned off, such as linking, high temperature
alarm, low battery alarm, stick operation mode switching, stick and key power-on self-test
alarm, etc.
Firmware Update
Using the DJI Assistant 2
1. Make sure the remote controller is powered o, and then connect the remote controller to a computer
using a USB cable with dual-A ports.
2. Power on the remote controller. Tap
on USB data export mode.
3. Launch DJI Assistant 2, and log in using a DJI account.
4. Click the DJI Smart Controller Enterprise icon, and then“Firmware Update”.
5. Select and conrm the rmware version you want to update.
6. DJI Assistant 2 will download and update the rmware automatically.
7. The remote controller will restart after update.
Using the DJI Pilot App
1. Power on the remote controller and make sure the Internet connection is functioning normally.
2. Launch DJI Pilot App, tap to enter the update page if the app shows that there is an ongoing
rmware update.
3. DJI Pilot will download and update the rmware automatically.
4. The remote controller will restart after an update.
Make sure the remote controller has more than 20% power before updating.
DO NOT disconnect the USB cable during the update when using DJI Assistant 2.
The update takes approximately 15 minutes. Make sure the remote controller or the computer
is connected to the internet during the update.