User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Profile
- Flight Mode
- Flight Status Indicator
- Aircraft Beacons
- Aircraft Auxiliary Lights
- Vision System and Infrared Sensing System
- Return-to-Home (RTH)
- Center of Gravity Calibration
- Flight Recorder
- Propellers
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Intelligent Flight Battery Functions
- D-RTK
- DJI AirSense
- Expansion Ports
- IP45 Protection Rating
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
74
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
PinPoint
PinPoint can only be used with the H20 series gimbal and camera. PinPoint can identify the location of
the target, which is convenient for information synchronization. When using an aircraft rmware version
of v03.00.01.01 or later, multiple Pin Points can be edited and managed and a Pin Point can be set as a
home point.
1. Adjust the attitude of the aircraft and the gimbal to move the target to the center of the view. Tap on
the target in the center of the view to record the point location.
2. Record the latitude, longitude and altitude of the point.
1. Tap to to record a point in the center of the map. The altitude of this point is the current aircraft altitude.
2. Tap to view the coordinates of the point, and the height of the point can be edited and deleted; press
and drag to change its latitude and longitude.
N
E
W
S
3
6
12
15
21
24
30
33
340
45m 222m
H
130.2
ALT
m
VS2.5
ASL1234.5
05.2
SPD
m/s
WS 04.0
H
In-Flight（GPS）
19:29
GPS
12
2.4G
80%
100%
26.1v
26.1v
IR
10 X
2 X
5 X
ZOOM
RNG
AE
AF-C
ZOOM 5.0X
WIDE
MENU
ISO
100
Shutter
1/1000
EV
0
123456
1
2
ALT: 200m / ASL: 1200m
56.096560, -12.987400
In-Flight（GPS）
19:29
GPS
12
2.4G
80%
100%
26.1v
26.1v
1
2
When using an aircraft firmware version earlier than v03.00.01.01, only one Pin Point is
supported. The previous Pin Point will be overwritten when the next Pin Point is recorded.